How to make inverter 12V to 220V using TL494
How to make a powerful Inverter 12v DC to 220v AC using TL494, 50hz 60hz Inverter. ( How to Make a 12v to 220v inverter using tl494 )
This is a 500-800W powerful Inverter. plz, don't use it for Motors.
Components used in this project:-
1.TL494
2.irfz44 x4
3. 100ohm resistors
4.100K Preset
5.470nf Cap
6. 2200uf/25v Cap
7. 12 0 12v, 10A Transformer or UPS Transformer
Hi, in this tutorial I'll show you how to make a 12V to 220V DC-AC inverter with the TL494 PWM IC for emergency lighting. The feasible power with the listed components is about 350 to 500 watts depending on the input voltage and cooling. Better performance can be achieved by using IRF3205 Power MOSFETS mounted on large heat sinks
Today I'll show you how to make a Regulated Inverter (DC to AC Converter) to step up 12V to 220V with possibility of limited range adjustment. The circuit is based on the TL494 General purpose PWM driver IC. With this, you can also alter the shape of the output AC waveform and vary the dead-time to get a modified sine wave AC of varying RMS values.
For the Transformer use a 12-0-12V to 220V AC one. If you Salvage one, retain the original mains primary winding if its not damaged, then make your own secondary center tapped winding (it will be the primary afterwards). Make about 10 turns and connect the original primary to mains, measure the voltage on your custom winding, and by relating the mains voltage, output voltage and custom winding turns, you can make an accurate estimate on the number of turns of the original mains winding . Now complete your custom winding to give you a step up ratio of 1:20.
How to make inverter 12V to 220V using TL494
How to make a powerful Inverter 12v DC to 220v AC using TL494, 50hz 60hz Inverter. ( How to Make a 12v to 220v inverter using tl494 )
This is a 500-800W powerful Inverter. plz, don't use it for Motors.
Components used in this project:-
1.TL494
2.irfz44 x4
3. 100ohm resistors
4.100K Preset
5.470nf Cap
6. 2200uf/25v Cap
7. 12 0 12v, 10A Transformer or UPS Transformer
Hi, in this tutorial I'll show you how to make a 12V to 220V DC-AC inverter with the TL494 PWM IC for emergency lighting. The feasible power with the listed components is about 350 to 500 watts depending on the input voltage and cooling. Better performance can be achieved by using IRF3205 Power MOSFETS mounted on large heat sinks
Today I'll show you how to make a Regulated Inverter (DC to AC Converter) to step up 12V to 220V with possibility of limited range adjustment. The circuit is based on the TL494 General purpose PWM driver IC. With this, you can also alter the shape of the output AC waveform and vary the dead-time to get a modified sine wave AC of varying RMS values.
For the Transformer use a 12-0-12V to 220V AC one. If you Salvage one, retain the original mains primary winding if its not damaged, then make your own secondary center tapped winding (it will be the primary afterwards). Make about 10 turns and connect the original primary to mains, measure the voltage on your custom winding, and by relating the mains voltage, output voltage and custom winding turns, you can make an accurate estimate on the number of turns of the original mains winding . Now complete your custom winding to give you a step up ratio of 1:20.
No comments:
Post a Comment