on video Led light blinking circuit | 12V LED Flasher Circuit

 Led light blinking circuit | 12V LED Flasher Circuit

Today I am going to make a circuit of LED Strip blinker using 12V Relay and capacitors.

Firstly we have to connect 150 ohm resistor to the Relay.

Solder 150 ohm resistor between NC (Normally close) pin and Coil-2 pin of the relay as solder

Next we have to connect 470uf capacitor to the relay.

Solder +ve pin of 470uf capacitor to NO Pin of the Relay and

Solder -ve pin of 470uf capacitor to Coil-1 Pin of the Relay as you can see

Next Solder +ve pin of 2200uf capacitor to Coil-2 pin of the Relay and

Solder -ve pin of 2200uf capacitor to coil-1 pin of the relay as you can see

Next we have to connect the wires of LED Strip.

Solder +ve wire of LED Strip to NO (Normally Open) Pin of the Relay and

solder -ve wire of the LED Strip to -ve of both capacitors/Coil-1 pin of the Relay as you can see in the picture.

Now we have to connect the clip of 12V DC Input Power supply.

Connect +ve clip of input power supply to Common pin of the Relay and

Connect -ve clip of Input Power supply to the -ve of capacitors/Coil-1 pin of the relay as you can see

Give Power supply to the circuit and now we will observe that LED Strip is blinking.

NOTE: Check circuit connections before giving input power supply.

 Led light blinking circuit | 12V LED Flasher Circuit

Today I am going to make a circuit of LED Strip blinker using 12V Relay and capacitors.

Firstly we have to connect 150 ohm resistor to the Relay.

Solder 150 ohm resistor between NC (Normally close) pin and Coil-2 pin of the relay as solder

Next we have to connect 470uf capacitor to the relay.

Solder +ve pin of 470uf capacitor to NO Pin of the Relay and

Solder -ve pin of 470uf capacitor to Coil-1 Pin of the Relay as you can see

Next Solder +ve pin of 2200uf capacitor to Coil-2 pin of the Relay and

Solder -ve pin of 2200uf capacitor to coil-1 pin of the relay as you can see

Next we have to connect the wires of LED Strip.

Solder +ve wire of LED Strip to NO (Normally Open) Pin of the Relay and

solder -ve wire of the LED Strip to -ve of both capacitors/Coil-1 pin of the Relay as you can see in the picture.

Now we have to connect the clip of 12V DC Input Power supply.

Connect +ve clip of input power supply to Common pin of the Relay and

Connect -ve clip of Input Power supply to the -ve of capacitors/Coil-1 pin of the relay as you can see

Give Power supply to the circuit and now we will observe that LED Strip is blinking.

NOTE: Check circuit connections before giving input power supply.