How to make arc lighter | Diy high voltage generator | Make a taser stun gun

 This device is capable of generating high voltage arcs, which can be used as an ignition system for a spud gun.

Or other things where High Voltage pulses are needed for testing purposes.

This device is chargeable with a micro USB cable.

The module is a small bit to big to fit inside the enclosure.

First cut the excessive part from the tube off.

Then you can use a piece of sand paper or a milling machine to trim the height of the module to fit inside the casing.

When I was using the milling machine the tube broke and I was able to take the whole tube off, which was also fine.

First solder the battery connector to the charge module.

solder the GREEN wire of the high voltage module to the charge module “-” connection

solder the RED wire of the high voltage module to one side of the switch

solder a wire from the “+” connection of the charge module to the other side of the switch

See how long you can make your arcs. This is important to know when placing the screws.

See where everything would fit inside the enclosure and make the holes for the components.

Cut the red high voltage wires to size

Strip the red wires and solder spacers to them

Drill the holes in the enclosure for the bolts to go through

assemble everything as in the picture

Test if everything works

Glue everything in place

 This device is capable of generating high voltage arcs, which can be used as an ignition system for a spud gun.

Or other things where High Voltage pulses are needed for testing purposes.

This device is chargeable with a micro USB cable.

The module is a small bit to big to fit inside the enclosure.

First cut the excessive part from the tube off.

Then you can use a piece of sand paper or a milling machine to trim the height of the module to fit inside the casing.

When I was using the milling machine the tube broke and I was able to take the whole tube off, which was also fine.

First solder the battery connector to the charge module.

solder the GREEN wire of the high voltage module to the charge module “-” connection

solder the RED wire of the high voltage module to one side of the switch

solder a wire from the “+” connection of the charge module to the other side of the switch

See how long you can make your arcs. This is important to know when placing the screws.

See where everything would fit inside the enclosure and make the holes for the components.

Cut the red high voltage wires to size

Strip the red wires and solder spacers to them

Drill the holes in the enclosure for the bolts to go through

assemble everything as in the picture

Test if everything works

Glue everything in place