Voltage Regulator Using LM317 | 0-15V
Hi Friends In this video i will make a simple Voltage Regulator Using LM317 IC - LM317 Can Give maximum current 2Amp (1.5V To 24V). In the next video I will show how to increase the current to 5Amps. and some of the next video i will add current limit to the LM317 Powersupply so it can regulate both voltage and current
1. You can adjust the Output voltage from 1.5 volt to 35 volt provided the input voltage is greater then output voltage by at least 2 to 3 volt
2. In the circuit the purpose of the Diode is to protect from short circuits.
a) Diode D1 protects from internal short circuits &
b) Diode D2 protects from external short circuits
The Circuit diagram for the voltage regulator is shown in the first image. Construct the circuit according to the circuit diagram.
Note: Don't Forget to connect an Heat Sink to the IC
To adjust the Output voltage fuse the trimmer pot. The Voltage can be adjusted from 1.5 volt to 35 vol & also note the input voltage should always be greater then the output voltage. In the circuit we have used two Diodes. The purpose of the diode is to protect from short circuits.
a) Diode D1 protects from internal short circuits &
b) Diode D2 protects from external short circuits
To watch the working of this circuit you can watch the video posted in the first step
Voltage Regulator Using LM317 | 0-15V
Hi Friends In this video i will make a simple Voltage Regulator Using LM317 IC - LM317 Can Give maximum current 2Amp (1.5V To 24V). In the next video I will show how to increase the current to 5Amps. and some of the next video i will add current limit to the LM317 Powersupply so it can regulate both voltage and current
1. You can adjust the Output voltage from 1.5 volt to 35 volt provided the input voltage is greater then output voltage by at least 2 to 3 volt
2. In the circuit the purpose of the Diode is to protect from short circuits.
a) Diode D1 protects from internal short circuits &
b) Diode D2 protects from external short circuits
The Circuit diagram for the voltage regulator is shown in the first image. Construct the circuit according to the circuit diagram.
Note: Don't Forget to connect an Heat Sink to the IC
To adjust the Output voltage fuse the trimmer pot. The Voltage can be adjusted from 1.5 volt to 35 vol & also note the input voltage should always be greater then the output voltage. In the circuit we have used two Diodes. The purpose of the diode is to protect from short circuits.
a) Diode D1 protects from internal short circuits &
b) Diode D2 protects from external short circuits
To watch the working of this circuit you can watch the video posted in the first step
No comments:
Post a Comment