Post Top Ad

Tuesday, November 29, 2022

on video Short circuit overload protection for Battery / Power supply


 I will show you how to make simple short circuit protection & overloading protection circuit that must be used in the power supply or battery to protect them if short circuit or overloading happened, This is simple electronic project that has also adjustable cutoff current limit setting upto 10A.

Required Components For This 3.7 volt battery charger circuit.


1.  12v 10A SPDT Relay

2. Green & Red LED

3. 1 Kilo Ohms Resistors (1/4w)

4. 100K multi-turn potentiometer

5. BC547 / BC548 Transistors

 today in this video I've shown how to make a simple short-circuit protection circuit using a relay. You can use this circuit 6v to 12v battery. But for 12V battery use a 12v relay. The load current depends on the relay's specification.


Components required:-

1 x relay ( Relay voltage as per your Battery )

2 x led

1 x 1K resistor

1 x push button switch

 


 I will show you how to make simple short circuit protection & overloading protection circuit that must be used in the power supply or battery to protect them if short circuit or overloading happened, This is simple electronic project that has also adjustable cutoff current limit setting upto 10A.

Required Components For This 3.7 volt battery charger circuit.


1.  12v 10A SPDT Relay

2. Green & Red LED

3. 1 Kilo Ohms Resistors (1/4w)

4. 100K multi-turn potentiometer

5. BC547 / BC548 Transistors

 today in this video I've shown how to make a simple short-circuit protection circuit using a relay. You can use this circuit 6v to 12v battery. But for 12V battery use a 12v relay. The load current depends on the relay's specification.


Components required:-

1 x relay ( Relay voltage as per your Battery )

2 x led

1 x 1K resistor

1 x push button switch

 

No comments:

Post a Comment

Post Top Ad

Pages